Skip to content
4.67K viewsSpork 1.x
0
0 Comments

Just received the 12mm conversion kit. How do I remove the 15mm threaded insert that’s installed? Will appreciate direction/guidance on installing the kit.

Steve The Intern Changed status to publish May 11, 2020
0

Stephen,

To remove the 15mm insert look under the bottom of the drive side fork leg where the insert is. There is a small set bolt there that needs to be backed out enough to allow the insert to release and pop out. When inserting the 12mm part be sure to align the small groove in the part with the axis of the set bolt so that when you re-tighten the set bolt it properly engages the bolt and holds it in place.

-Rodeo

Steve The Intern Changed status to publish May 11, 2020