The routing endcap screws are 4mm diameter, 5mm depth, with a conical head.

The rear dropout hardware screws are 3mm diameter, 13mm depth, conical head.

Definitely always outboard T-47 on all of our frames.

Jeff. Thanks for the question. We’ve run a very wide range of power meters on TD3 and none have shown any issues. Here is a list of what we’ve tried:

• Quarq
• Praxis / 4iii
• Easton Cinch
• Stages – requires shims to space it on the non drive side.

We haven’t tried Power2Max but I can’t think of an obvious reason they wouldn’t work. We were pretty careful to make the bike generally as compatible with a wide range of cranksets and chainrings. That doesn’t mean that someone won’t eventually find something that doesn’t work but so far so good.

Chris. You are correct. M5 x 10.

You would be totally fine running a 50/34 oval on Flaanimal or Traildonkey.

I want to run 2x, on spec sheet it says max 50/34t wondered how the dimensions of an oval ring affected that?

Hamish,

It is definitely possible to run Absolute Black rings on the bike. Are you considering 1x or 2x?

Stephen,

Thanks so much for your fast reply and information. I have always felt my current set up was a little small so I think I would go 56 for a TD3. I will keep and eye out for naked in 56 to be back in stock.

Cheers,

Jean-Paul

Hi Jean!

Your road setup seems really unique for fit. On a 54cm we are typically speccing about a 90mm stem but we can spec any stem length you like. At 5’10” you would traditionally fit a 56cm based on 90% of the fits we do.

Naked 54 should be back in stock early May.

Thanks

Thank you for the input!